5
⚠
This product is for a single user. Do not attach multiple users to this product.
⚠
The connecting system shall contain a personal energy absorber.
⚠
Do not attach to any other point on the TempLink 5000 other than the specified
attachment point.
⚠
Use of incompatible connectors may lead to forced roll out and unintentional
disconnection.
⚠
Always consult the connecting system manufacturer's instruction to ensure it is
suitable for use with this equipment.
⚠
During use always allow for the required fall clearance, swing fall and hazards present
in the work place.
6
Storage, Transport and Maintenance
6.1
Storage and transport
This equipment shall be stored and transported in a cool, dry environment, away from any
hazards and out of direct sunlight.
6.2
Maintenance
6.2.1 The TempLink 5000 Single Point Anchor is non serviceable. The equipment may remain
in service until it fails an inspection or is involved in a fall.
⚠
Do not attempt to modify or disassemble this product.
6.3
Cleaning
The TempLink 5000 may be cleaned by the end user periodically to increase service life. After
cleaning, the product shall undergo the pre-use inspection. Clean with a rag and warm water
to remove dirt and grit. A mild detergent may be used to remove grease or oils from the
product.
⚠
Do not store this product when wet. Allow the product to dry and conduct a pre-use
inspection prior to returning the item to service.
7
Inspection
7.1
Before and After Use
The TempLink 5000 Single Point Anchor shall be inspected before and after each use by the
user.
7.2
Competent Person
A competent person shall inspect the product at least every 12 months.
7.3
Procedure
7.3.1 Attachment point - inspect for damage, deformation, corrosion or signs of over loading.
7.3.2 Fall Indicators - inspect tabs are intact.
7.3.3 Screw Surface - inspect for damage, deformation, corrosion, signs of over loading
twisting buckling.
7.3.4 Energy Absorber - inspect the serpentines lay flat and inline with the product. Inspect
the energy absorber is free of cracks, dirt, debris, defects, damage, deformation, corrosion,
signs of over loading.
7.3.5 Markings - inspect all markings are present and legible. Figure 10.
