Safety Hoist AH-300, Руководство по эксплуатации

Страница: 9 / 21

7
11. Turn the hoist up on its side with brake drum up.
12. Push forward on the brake handle to release the brake. (Note you will only need
to have it rotate 10-15 degrees, 1 – 2”, to release the brake).
13. While the brake is released, pull out cable from the winch drum. Draw out enough
cable to run up the back side of the track, thru the peak pulley and back down to
the carriage on the front side (The carriage side). See Figure 6
Figure 6
14. Attach the thimble on the cable to the back of carriage using the 1/2" bolt, nut
and washers. Put 2 1/2" washers between thimble and carriage and 1 1/2"
washer on other side of thimble. Pass the bolt thru the washers, thimble and
then thru the bumper side angle then center hole on carriage. Tighten the 1/2"
bolt so it passes thru the nut, but not so tight as to stop the thimble from
rotating on the bolt. See Figure 7
Figure 7