44
LATCH Installation
1.
Remove LATCH from
Storage Location
Or remove from rear-facing
belt path if LATCH was used
rear facing.
WARNINGS:
Do not use the lower anchorage system
(LATCH system) to attach this child restraint when restrain-
ing a child weighing more than 40 lbs (18 kg) with the
internal harnesses of the child restraint.
Do not use LATCH along with the vehicle lap or lap/shoul-
der belt.
Check LATCH belt before each use. Use only if the belt can
be tightened properly and securely.
Failure to follow these warnings can result in serious
injury or death.
Review your vehicle owner’s manual for LATCH belt use.
continued on next page
43
2.
Route LATCH Belt
Through Forward-
Facing Belt Path
Do not twist belt.
LATCH adjuster can be on either
side.
4.
Place Child Restraint
Forward Facing Flush
Against Vehicle Seat
Back
Do not use any recline positions
except to make the child restraint
flush against the vehicle seat back.
Vehicle seat back must be upright.
3.
Finished LATCH Routing
5.
Loosely Attach Tether
Hook
Consult vehicle owner’s manual for
specific location.
Safety Tips:
Make sure harness and buckle fit your child correctly before
installing the child restraint. See pages 3-5.
Experts agree that children should remain rear facing as long
as possible. In this child restraint, your child can remain rear
facing up to 40 lb (18 kg) and up to 40 in. (101.6 cm).
4358-6653 Grow and Go 3 in 1.indd 49-50
4358-6653 Grow and Go 3 in 1.indd 49-50
4/15/15 8:48 AM
4/15/15 8:48 AM