Safety 1st Grow and Go 3-in-1, Инструкция по эксплуатации, Страница: 14 / 32

Installing Harness System
22
2. Insert Buckle’s Metal
Retainer into Slot
Closest to Child
Buckle MUST face out. You MUST
use the 1st or 2nd buckle slots
when child restraint is used rear
facing. Any slot can be used when
forward facing.
1. Fully Recline the Child
Restraint
Pull out on recline handle and push
top of child restraint back.
4. Check Buckle
Pull up on buckle to make sure it
is secured. The buckle
MUST not
pull out.
You MUST always use the
buckle cover. Slide end of
buckle cover into buckle slot in
pad.
If you have removed the harness straps from the
splitter plate, and the buckle tongues and chest
clip have been unthreaded from the harness
straps, follow the steps below to rethread them.
3. Reach Under Seat
Between Base and Shell
and Through Recline
Handle
Pull metal retainer completely
through pad and shell.
1
2
3
21
1. Thread Buckle and
Chest Clip
Harness strap ends go through
the
back of buckle tongues and
through the chest clip front to
back as shown.
5. Adjust the Headrest
to the Highest Position
6. Undo Fasteners on Seat
and Headrest Pad and
Pull Headrest Pad Off
Bottom of Headrest
Unthread harness straps from slots
on side of headrest.
Loosen harness straps.
Pull chest clip, harness straps, and
buckle tongues out from behind
the headrest and seat pad.
Slide harness straps into slots
in headrest pad and in seat pad.
Attach fasteners.
continued on next page
4358-6653 Grow and Go 3 in 1.indd 27-28 4358-6653 Grow and Go 3 in 1.indd 27-28 4/15/15 8:48 AM 4/15/15 8:48 AM