SAFETRACK ECONECT SAFE 94350, Руководство пользователя

Страница: 15 / 24

7
MAINTENANCE ON S15
15
3. Check that the ring holder is the right type. You can remove
it by hand and its ease of removing can be adjusted with the
small screw on the side of the gun (see photo).
4. Load the gun with the appropriate pin & ferrule.
Check that the axle moves easily with the pin and ferrule
installed by pushing back and forward on the pin with your
finger (see photo).
If the pin does not move easily, change either pin holder or
ring holder. If it still does not move easily the axle is damaged
and must be sent for repair.
1. Check that all cables and lugs are without damages
and properly tighten in gun and unit.
2. Check that the right pin holder is fitted in the gun.
Make sure the pin holder is tight on the gun,
otherwise a spark can destroy the axle.
Use a wrench to hold the nut from turning and tighten
the pin holder as shown in the picture.
Do not allow the main shaft to turn, only turn the pin holder
to tighten.
Use one 8 mm and one 10 mm wrench for 8-9,5 mm and
M8 pin holders.
Two 10 mm wrenches for M10 and M12 pin holders.
The pin holder must also have a tight grip on the brazing pin,
otherwise you can have a contact fault or a spark can arise
and destroy the pin holder. To get a tighter fit, push the pin
holder flares closer together with your fingers.
Make sure, never twist the axle when mounting the pin holder!
IMPORTANT
PERIODICAL MAINTENANCE ON S15 AUTOMATIC GUN