Service Life Label
Care and Maintenance
The webbing and seating platform can be cleaned on the restraint with a damp cloth using mild soap solution and lukewarm water.
The pad can be removed for machine washing in cold water on gentle cycle and tumbled dry on low heat. Do not use chlorine
bleach or dry clean the pad.
The seating pad is connected to the base with the use of hook and loop fasteners. To remove, pull up on the pad to remove from
the base and disconnect the hook and loop fasteners on the back of the pad in two places.
If the seating pad becomes overly soiled or damaged, a replacement pad can be ordered from your original place of purchase or by
calling 877-447-2305.
STAR Restraint Replacement
The STAR restraint system is considered to have a finite life and must be frequently inspected and replaced as needed. The default
service life of a STAR restraint is 6 years from the date of manufacture. You may also use the date of invoice by following the
directions below. Use of the STAR must be discontinued six years after the date of invoice or the date of manufacture if the invoice
information label is not completed. The date of manufacture can be found on the back of the lower portion of the cam wrap strap
where it connects to the seat base
(Figure 1)
.
To activate service life from date of invoice, locate the information label on the side of the STAR base. You must enter Invoice
Date, Invoice number, and name of the seller of your STAR. All information must be entered for this to be valid. Remove the
backing from the label clear cover and seal the label with the information you have entered
(Figure 2)
.
The STAR and its components must be inspected frequently (per instructions below). If you have any doubts about the condition or
function of the restraint, REPLACE IT, even if it is less than 6 years from the date of service expiration.
If any component or part of the STAR restraint requires replacement (with the exception of the replaceable pad), the entire system
must be replaced.
11
Figure 2
Invoice Date
Invoice Number
Distributor Name
Label must
be filled out
completely.
Figure 1
Date of Manufacture
