(208) 773-9263
A Product of
All rights reserved © 2018
Master Sensitivity Settings
Access to the Master Sensitivity Setting is for “Management-Use” Only.
Management should set Compass’s sensitivity setting based on the worker’s level of training around
high voltage equipment. Allowing your employees to have access to this setting will make you liable
for any changes that may be made on the device. Each Compass across the workspace should be set on
the same sensitivity to reduce risk of injury. If your device settings aren’t consistent, those units with
different settings could expose your employees to unintended threats. When “Power Down” is activated
on Compass, the prior sensitivity settings will remain on the device. When Compass is turned on, the
display will briefly indicate the device’s “pre-set” sensitivity setting. It is the Employer’s responsibility to
manage the sensitivity settings for their employees.
To access Compass’s sensitivity settings, you must connect the device to the micro USB charger. Once
Compass is charging, hold the center button down for 5 seconds until the original blue charging light
transitions into an array of red lights indicating the adjustable
AC VOLTAGE
menu. Once you are in
this menu display, quickly press the center button to change the device’s sensitivity to Low (3 lights),
Medium (5 lights), High (7 lights), or Adaptive (all lights grow inward and outward). Once the desired
sensitivity is selected, hold the center button until the corner lights turn green. Once released, the array
of blue lights indicates that you’re now in the adjustable current menu. Once here, you can now adjust
the sensitivity of Compass’s
CURRENT
detection. With the same controls used to previously to operate
the
AC VOLTAGE
menu, set your desired
CURRENT
sensitivity to Low (3 lights), Medium (5 lights), or
High (7 lights). Once desired sensitivity is displayed, hold the center button until the exterior lights turn
green. Once the center button is released, the device then returns to its charging state indicated by the
blue charging light. At this point Compass is free to be unplugged from its micro USB and can be used
in the field.
Each time the Compass is turned off - by holding the center button for 5 seconds - and then turned back
on, a quick press to the center button will reveal management’s preset sensitivity settings for both
AC
VOLTAGE (Red)
and
AC CURRENT (Blue)
. This will inform the user of the current sensitivity setting of
the Compass. Once both settings have been displayed, Compass is available to use in the field.
