SafeGuard Go HARNESS, Инструкция по эксплуатации

Страница: 10 / 40

16 17
WARNING
FAILURE TO FOLLOW THESE VEHICLE SEAT BELT REQUIREMENTS
CAN RESULT IN SERIOUS INJURY OR DEATH.
SOME VEHICLE SEAT BELT SYSTEMS ARE NOT ACCEPTABLE TO USE
WITH THIS CHILD RESTRAINT.
Vehicle Seat Belt Requirements
Unacceptable Vehicle Seat Belt Systems
DO NOT USE ANY OF THE FOLLOWING SYSTEMS WITH THIS CHILD
RESTRAINT.
• Lap belt with an emergency locking
retractor (ELR)
This type of lap belt stays loose and can
move until it locks in a sudden stop or
crash. This vehicle seat belt may NOT safely
hold a child restraint in place. DO NOT USE
this type of belt system unless the vehicle
owner’s manual or label states the belt can be locked at all times.
NEVER use a lap belt only when using the child restraint in a belt
positioning booster mode.
Make sure you understand the seat belt systems in your vehicle. Carefully
read this section on belt systems and also refer to the vehicle owner’s
manual and any labels on the vehicle seat belts. If you are unsure
whether the vehicle seat belts are acceptable to use, contact the vehicle
manufacturer or call SafeGuard Customer Service at 1-800-586-7839.
• The vehicle lower anchors may be visible
at the vehicle seat bight (seat crease). If
not visible, they may be marked with one
of these symbols.
• The vehicle’s tether anchors may be
visible. If not, they may be identified with
this symbol.
• ONLY use LATCH on this child restraint in
a seating position recommended by the
vehicle manufacturer.
• LATCH and the center-rear seating
position: Do not use the inner
lower LATCH anchors to install
the child restraint in the center-
rear seating position, unless:
- the vehicle owner’s manual
specifically indicates it is
allowed, AND
- the inner anchors are spaced
between 11 and 20 inches
(280 and 500mm) apart.
• Never attach two LATCH
connectors to one LATCH anchor.
When using the harness mode:
• Never use both the lower LATCH anchors and the vehicle seat belt
system at the same time to install this child restraint.
• Always use the tether!
LATCH Requirements cont’d.
11 - 20 inches
(280 - 500mm)
Inner
Lower
LATCH
anchors
Outboard
LATCH
Position
Outboard
LATCH
Position