
8
Remove the backing tape from the Spirit Level
(F1) and stick it lengthwise on the side of the
Locking Rail towards the top.
Position the base of the Locking Rail on the
floor where you wish to fit the gate, make the
Rail vertical (the bubble inside the Spirit Level
centred), and pass the Marker (F2) through
the hole at the bottom of the Rail, to mark the
drilling point. Move the Spirit Level, and repeat
this step for the Hinge Rail.
Drill the lower fixing holes appropriate to the
type of wall that you are fixing your Gate to -
refer to
’Before you start’
.
If you are fixing to a brick or concrete wall,
insert the Wall Plugs (G) into each hole.
7
Remove the two screws in the very top of
the Locking Rail, then lift off the top cap and
magnet lock.
UK