Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
6
FEA-0002
ASSEMBL
Y INSTR
UCTIONS–L & Z POSTS
Beginning with the Rear
Crossbar, loosen the bolt at the
bottom of the Auto Clamp, then
slide the Auto Clamp toward the inside
end of the Rotation Upper. Reposition
the Auto Clamp leaving a minimum
of 1/4” distance from the rubber
bumper to the edge of the Auto Clamp
Bracket as shown, then finger-tighten if
adjusting later, or torque to 80 in-lbs.
Ensure the Auto Clamp Spring is
seated into the spring catch
4.3
L Post seats into the
Crossbar’s inside bottom
groove as seen from the
front of the Rear Crossbar
4.2
Place an L Post into the bottom
groove of the Rear Crossbar
Slide L Post Bracket Clamp
into bottom groove, then slide
into L Post Bracket as shown
4.4
4.6
Assemble the L Post
hardware. Do not
tighten until Step 4.8
Bracket Clamp sits
in L Post Bracket
as shown
4.5
Note:
The orientation of
the bolt hole faces away
from the Crossbar
L POSTS
SEE QUICK START GUIDE FOR ADJUSTMENTS
NOTE:
The Auto Clamps come preset from the factory for
packaging purposes only. To assemble the L Posts to the
Crossbars, the Auto Clamps must be repositioned.
4.1
