Safe Fleet Prime Design FBM-1067-BLK, Руководство пользователя

Страница: 4 / 12

Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
4
6.00”
5.60”
6.00”
5.60”
⅝ ” 5.60”
Center
Rear
Front
A
B
A
A–Tall Mounting Bracket
Front & Rear Crossbars
B–Short Mounting Bracket
Mid–Crossbar only
Vehicle
Rear
Vehicle
Front
Z Plate
FBM-1067-BLK
ASSEMBL
Y INSTR
UCTIONS–ERGORA
CK GUTTER MOUNTS
2.4
Torque all of these Crossbar
Clamp nuts to 90 in-lbs
CROSSBAR ADJUSTMENT
2.1
CROSSBARS
Shown with LH Base, and RH Rotation for illustrative purposes only
1.5
Loosen the Mounting Z Plate
Cam Nut, but do not remove
1.6
Rotate the Mounting Z Plate
Cam 180° to allow the Z
Plate to rest at its full bottom
position. Do not tighten the
Cam Nut until Step 3.4.
Repeat Steps 1.1–1.6 for the
second Mounting Bracket.
Position the applicable Mounting Brackets according to the
illustrations shown below while ensuring all bolts protrude
inward as noted on page 2.
2.2
Ensure the Mounting
Bracket Clamps fully seat
into the Crossbar bottom
grooves as shown. Lightly
snug the nuts to allow for
adjustment in Step 2.3
Repeat this procedure for
all Mounting Brackets.
2.3
Position all Crossbars onto the
Mounting Brackets according to
the dimensions shown below.