Position the two E L-Shaped Grids, the F Front
Grid, and one of the G Large Grids around the base
grid as shown. Attach the grids to the base grid
using two H Metal Clips per grid section.
3084-37: Rev 1; 2 of 3; 7/97
Install the four A Casters onto the pads of the B
Base Grid. Secure each caster with four C Screws
and four D Nuts.
1
o
o
o
o
2
Swing the face panel and one L-shaped panel up 90
degrees, and attach them together using two metal
clips, as before. Continue with the other grids until
all four sides are up. Place the I Outer Support Bar
over the unit, and attach it to the grid panels (at the
top of the lower level) with metal clips. Lay the J
Dust Guard inside the bottom of the unit.
3
Insert the remaining G Large Grid into the center of
the unit as shown, and secure with metal clips.
4
o
o
o
o
Safco Products Company, New Hope, MN 55428
Insert the K Small Grid Divider into the center of
the front opening as shown, and attach with metal
clips. Do the same with the L Large Grid Divider,
centered in the back opening.
5
o
AT EACH
CONNECTION,
LOCATE CLIPS
APPROXIMATELY
WHERE INDICATED
o
o
o
o
H
o
E
o
E
o
G
o
F
o
B
o
A
o
C
o
D
o
J
o
I
o
G
o
L
o
K
o