HANGING THE FAN
8
1. Install flushmount assembly
Flushmount Installa on Only
1. Loosen the set screws in the support rod coupler located on the top center of
the motor housing un l the inside channel is clear.
2. Remove and save the safety screw from the coupler.
3. Place the ceiling canopy on the top of the motor housing and secure with the
three moun ng screws.
Slide the canopy up into place over the ceiling moun ng bracket. Loosen up
the canopy screws on the side of the canopy screws. Press the canopy against
the moun ng bracket and turn it clockwise. Tighten screws on the J Slots and
install the two screws in the remaining holes .
2
.
Flushmount Installa on
3 pcs big screws
Ceiling Canopy
Support Rod Coupler
Moun ng Bracket
Canopy
Phillips
screwdriver