WARNING: Failure to properly install the locking pin could
resultn the fan becoming loose and possibly falling.
WARNING
7
1. Thread the suspender through the suspended clock and coupling cover.
2. Then insert the tail of the suspender from the li ing head of the motor.
3. Remove the lateral pin out from the suspended head posi on, secure with
R type pin(Clevis pin).
4. Tighten the li ing head screws. Tighten the 2 Set Screws on the Coupling to
serve as a clamping force on the Downrod to prevent fan shaking during opera on.
5. Route the Coupling cover, Canopy Ring, Canopy and Hanger Ball through the
Downrod in turn, and then install the Lock pin through the hole on the Downrod.
Fix it by Screw, then slip down the Coupling Cover in correct posi on.
1. install downrod assembly
2. Suspended Installa on
HANGING THE FAN
STEP 2:
Phillips
screwdriver
R type pin
1. No ce the half ball on the end of the support rod is grooved down one side.
This key way fits over the small keyway pin on the inside of the moun ng bracket
and keeps the ceiling fan from spinning on the moun ng bracket.
2. Using your step ladder, li the fan and place the half bathe center of the moun ng
bracket withthe kepin inserted into the keyway on the ball. Turn the fan le and right
slightly to make surelated on the bracket with the keway.
3. Slide the canopy up into place over the ceiling moun ng bracket.
Loosen up the canopy screws on the side of the canopy screws.
Press the canopy against the moun ng bracket and turn it clockwise. Tighten screws on
the J Slots and install the two screws in the remaining holes.
Ball Hanger
Support Rod
Keyway Pin
Moun ng Bracket
Moun ng
Bracket
Canopy
