Copyright Safari Automotive Pty Ltd Melbourne Victoria Australia - www.safarisnorkel.com
Page 3 of 4
6.
Install the upper mounting bracket (item 3) to the snorkel body ((item 1)
with hex bolts (item 4). Apply Loctite 243 to each of the stainless steel
mounting studs (item 9) and install the studs finger tight into the snorkel
body (item 1) mounting inserts.
7.
Locate snorkel on vehicle and carefully mark around outside of upper
mounting bracket with a pencil. Remove snorkel from guard. Remove
upper mounting bracket and place in position on “A” pillar. Carefully
mark out 4 holes and drill to 8mm. De-burr and paint holes.
8.
Insert plastic plugs and fit upper mounting bracket to “A” pillar.
9.
Fit snorkel to guard and fasten using necessary hardware.
10. Fit flexible duct to snorkel and tighten 60/80 hose clamp. Refit air
cleaner assembly and connect flexible duct to air cleaner and fasten
60/80 hose clamp.
10
Refit wheel arch liner and fasten air ram to snorkel.
N.B: It is the installer’s responsibility to ensure that all connections are
watertight.
