17
XL-AS20067BM-en-US · 2021-02-05 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Hanger Mounted Lift Bracket Replacement
Figure 17
Figure 16
8. Install the pivot connection hardware
(Figure 16)
.
NOTE:
Make sure the SwingAlign washers and
components are in place prior to tightening the
pivot connection. Tighten until spline is sheared.
9. Re-attach the air line to the PosiLift air spring.
NOTE:
Before attaching to the PosiLift air spring ensure
that the air line is fed through the grommet in
the new lift bracket
(Figure 17)
.
10. Check for air leaks by applying a soapy water solution
and checking for bubbles at all connections and fittings.
If leaks are found, repair as necessary.
IMPORTANT:
It is the responsibility of the air system
installer to secure all air lines and check
for air leaks. If air leaks are detected,
repair as required.
Failure to eliminate air leaks could
compromise the suspension performance
which, if not avoided, could result in
component or property damage.
11. Remove the jack stands.
NOTE:
It is recommended to re-align the trailer axle
after the pivot connection is taken apart. Refer to
Section 8 for alignment procedures.
WASHER
WASHER
COLLAR
COLLAR
PIVOT
NUT
PIVOT
BOLT
FRAME
BRACKET
