SAF-HOLLAND SK RB 9022 K, Руководство по обслуживанию и ремонту

Страница: 24 / 32

24
D) Installation instructions
Press the new guide sleeve together at the collar and insert into the
bore from the inside of the brake calliper.
Push guide sleeve (70.3) into the bore until the collar of guide sleeve
(70.3) engages positively in the shoulder of the bore (arrows).
Caution!
On no account should the mineral oil-based white grease
(SAF Part No. 4 387 0016 00) be used in the guide sleeve. Use only
green (SAF Part No. 4 387 0017 00 / mineral oil-free) grease.
Note:
The guide and seal kit includes a new guide bush (short) and a new
hex. socket head screw.
Install the guide bush.
Install the brake calliper.
Notes:
Tighten the hex. socket head screws to 290 Nm and check that the
brake calliper can move freely.
Replacing the brake calliper
Caution!
Do not repair the brake cylinder due to the “inner sealing”. Use
only an original replacement cylinder.
Removing the brake calliper
Remove the brake pads.
Remove the diaphragm cylinder.
Loosen and remove band-type clamp (82.1) and remove boot cap
(82.2).
Unscrew hex. socket head screws (80.1/81.1) and (70.1).
New type steel cap: dismantle steel cap 83.1.
Remove the brake calliper from the brake calliper carrier.
RISK OF CRUSHING!
Hold the brake calliper only on the outside; never place your
fingers between brake calliper and brake calliper carrier!
RISK OF ACCIDENTS!
Opening or dismantling of a brake calliper is not permitted.
Use only replacement brake callipers.
70.3
82.2
80.1/
81.1
70.1
83.1
82.1
82.1
82.2
83.2