15
In order to avoid environmental contamination or undue use of the Equipment after it has become
useless, it should be discarded in the suitable place (as per the local legislation of the country).
- Pay attention to the local legislation of the country for the conditions of installation and disposal of
residue.
Precautions to be adopted against foreseeable or uncommon risks, related to
the deactivation and abandoning of equipment
- If the equipment has any abnormality, check if the problem is related to any item listed in the
topic of unforeseen events (failures, causes and solutions). If it is not possible to resolve the
problem, turn off the equipment, remove the power supply cable from the socket and contact your
representative (Saevo).
Precautions in case of alteration in the functioning of equipment
CORRECTIVE AND PREVENTIVE MAINTENANCE AND PRESERVATION
Cleaning
Important: In order to execute cleaning or any type of maintenance, ensure that the equipment is
disconnected from the electrical network.
Additional procedures for reuse
The equipment can be reused in undetermined, i.e. unlimited, quantities, only needing to be cleaned
and disinfected.
Precautions and warnings during the “cleaning and disinfection” of equipment
- Before cleaning the equipment, turn off the main switch.
- Avoid spilling water or other liquids inside the equipment, which could cause short circuits.
- Do not use microabrasive material or steel wool when cleaning, or employ organic solvents or detergents
which contain solvents such as ether, stain remover, etc.
NOTE:
Changing in visual appearance inner the destiladora tank is a normal feature of the product
due to the heating of it.
- Spots and oxidations signs may occur due to the continuous use and it is totally or partially
removed according to the recommended procedure as below:
In order to execute the internal cleaning of your destiladora we recommend using the product
“Steel-Clean”. Product notified at ANVISA/MS.
WARNING:
Perform cleaning according to specified by the manufacturer (see the packing label). In
the case of incorrect cleaning procedure it may occur a darkening in the surface.
Internal cleaning of the tank:
The registration at the Ministry of Health of “Steel-Clean” is performed separately from the
product described in this manual, as the “Steel-Clean” is not manufactured by Saevo.
Product Composition:
Surfactant anionic, inorganic acid, sequestrant, preservative, dye and vehicle.
WARNING:
After the cleaning procedure perform a complete cycle of distilling and then eliminate
the water of the reservoir and dry the tub using a clean cloth.
PRECAUTIONS, RESTRICTIONS AND WARNINGS
