SAelen TS GS/TIGER 25D, Техническое руководство

Страница: 35 / 60

DISASSEMBLY TO REPLACE THE BLADES AND THE HAMMER INSERTS
Remove the ignition key before proceeding
-The hollow hexagonal screws of the blades and hammer inserts are mounted in the facture using LOCTITE normal
243 . Use the appropriate wrench that is in good condition to remove them.
-Open the chute as described on page 25.
-Remove the screws from blades and inserts. (For the assembly later on, only use new and degreased screws).
-Clean the contact surfaces of the blades and the inserts clean at the base (1) as well as the wall (2) .
Maintenance and Service
-Install identical or newly ground blades.
IMPORTANT: the blades must be ground by a professional using specific tools, and not with a grinding disc. Make
sure tha 35° angle of the cutting edge is respected. The minimal lengt of A should not be smaller than 50 mm after
grinding. (The length of a new blade is 60 mm). (next)