Saeco Tchibo Cafissimo HD8603, Руководство по эксплуатации

Страница: 38 / 88

• 28 •
Monthly cleaning of the milk carafe
In order to keep the entire circuit free of
milk residue and to guarantee the best and
long-lasting performance of the carafe, we
advise performing a monthly cleaning cy-
cle with ''Saeco Milk Circuit Cleaner'', which
is sold separately.
Before starting the cleaning cycle, check that the
On/Off button and product buttons are con-
stantly lit and that there is enough water in the tank.
1-
Remove the milk carafe lid and wash both components in luke-
warm running water.
2-
Fill the carafe up to the MAX level with fresh, lukewarm water.
3- Pour the detergent product into the milk carafe and let it dis-
solve fully.
4- Replace the lid on the carafe, insert it into the machine and
place a container under the milk dispensing spout.
Warning! Dispensing may be preceded by small jets
of hot water: danger of scalding! If the carafe is ab-
sent, products requiring milk should not be selected.
Never drink the solution dispensed during this
procedure.
5- With the machine turned on, press the Frothed milk button .
Wait until it has finished dispensing.
6- Empty the container and place it back under the milk dispensing
spout.
7-
Repeat steps 5 to 6 until the milk carafe is empty, then proceed to
step 8.
8-
Remove the carafe from the machine and wash thoroughly with
fresh water.
9- Fill the milk carafe with fresh drinking water up to the MAX level
and then place it back in the machine.
10- With the machine turned on, press the Frothed milk button .
Wait until it has finished dispensing.
11-
Press the rinse button (orange). Wait until it has finished
dispensing.
12-
Empty the container and place it back under the milk dispensing
spout.
13- Repeat steps 10 to 12 until the milk carafe is empty, then proceed
to step 14.
14- Remove and wash the milk carafe as described in the section
“Weekly cleaning of the milk carafe”.
12- Wash the carafe lid with lukewarm run-
ning water.
Do not place the carafe lid in the
dishwasher to prevent the part
from discolouring.
13- Open the dispensing spout lid.
14-
Remove the lower part of the dispens-
ing spout.
15- Wash all the components with luke-
warm running water. The internal parts
of the frothing system are dishwasher
safe. When all components have been
washed, reassemble them following the
same procedure, but in reverse order.
10- Remove the dispensing spout from the
fitting.
11-
Remove the fitting from the rubber
tube.