46
error Codes
gUIDE mESSAgE THAT APPEARS
HOW TO REmOVE THE mESSAgE
restart the machine
turn off and after 30 minutes turn the machine on again
to restore normal operation.
call assistance
contact an authorized service center.
insert drip tray
insert drip tray
under the brew group
.
close coffee bean container
Close the coffee bean hopper cover to be able to brew
any beverage.
add ground coffee
Add one scoop of pre-ground coffee to the pre-ground
bypass doser.
insert brew group
Insert the brew group in its place.
insert dreg drawer
insert the
dregdrawer.
empty dreg drawer
remove the
dregdrawer
and empty the grounds in an
appropriate container.
note: the
dregdrawer must be emptied only when the
machine signals to do so, and when the machine is
turned on.
Emptying the drawer with the machine turned off does
not allow the machine to register that it has been
emptied.
close side door
close the side door of the machine.
refill water tank
Refill the water tank with fresh drinking water.
empty drip tray
open the side door and empty the drip tray under the
brew group.
insert the milk container
insert the milk container in its compartment.
prime the machine
Press on the display in order to proceed with manually
priming the water circuit. The machine performs an
automatic attempt to prime the circuit. if this attempt
does not perform correctly you must proceed with these
instructions.
circuit priming failure
contact an authorized service center.
the descaling cycle has not been completed
correctly
Repeat the operation as described in the descaling
section.
milk rinsing
See page 13 and 28.
milk cleaning
See page 13 and 29.
prime the circuit
Set the SBS dial to the position shown on the display
screen, and proceed with cleaning the brew group. Then,
prime the circuit once again.
