• 19 •
English
• Wait until the machine ready light (5) turns on again. The
machine is now ready to dispense steam.
•
(Fig.17)
- Insert a container below the steam spout and
open the knob (7) for a few seconds, so that any residual
water
fl
ows out of the steam spout (Pannarello). Wait until
there is a steady jet of steam coming out of the spout.
•
(Fig.19)
- Close the knob (7) and remove the container.
• Fill 1/3 of a frothing pitcher or large mug with cold milk.
Use cold milk to get better results when frothing. Milk
with higher fat content will produce thicker froth.
•
(Fig.21)
- Immerse the Pannarello spout in the milk and
open the knob (7). Rotate the container with slow upward
movements so that it warms evenly.
•
(Fig.22)
- After frothing the milk, close the knob (7), and
remove the pitcher/cup with frothed milk.
•
(Fig.20)
- Press the steam button (6) again.
• Prime the circuit as described in section 4.5 to make the
machine ready for use.
The same procedure can be used to heat other
beverages.
•
(Fig.23)
- After steaming/frothing, clean the steam spout
thoroughly with a wet cloth, as described in the following
section.
9 CLEANING THE MACHINE
Maintenance and cleaning can only be carried out when
the machine is cold and disconnected from the power
supply.
• Do not immerse the machine in water or place any of its
parts in a dishwasher.
• Do not use alcohol-based cleansers, solvents and/or
aggressive chemical agents.
• We recommend cleaning the water tank and re
fi
lling it
with fresh water daily.
•
(Fig.23)
- After frothing milk, dispense a small quantity
of hot water to clean the inside of the steam spout.
Use a soft, dampened cloth to clean the outside of the
Pannarello frother.
•
(Fig.24)
- Empty and clean the drip tray daily.
• Use a soft, dampened cloth to clean the appliance.
•
(Fig.16)
- To clean the porta
fi
lter proceed as follows:
- Remove the
fi
lter, wash it thoroughly with hot water.
- Wash the inside of the portafilter thoroughly with
running water.
• Do not dry the machine and/or its components using a
microwave and/or conventional oven.
10 DESCALING THE MACHINE
Limescale is a result of mineral deposits from water.
This normally builds up with the use of the appliance.
Descaling is necessary every 2-3 working months and/or
when you notice any reduction in water
fl
ow.
You can use a non-toxic and/or non-harmful
descaling product for coffee machines,
commonly available in retail stores. We recommend
using Saeco descaling solution.
Warning! Do not use vinegar or lemon juice
as a descaler.
• Remove and empty the water tank.
•
(Fig.2)
- Mix the descaling solution with water as speci-
fi
ed on the packet of solution, and
fi
ll the water tank. Fit
the tank into the machine.
•
(Fig.4B)
- Switch on the machine by pressing the power
button (2).
•
(Fig.5)
- Place a container under the steam spout.
• Open the knob (7) and press the brew button (4) to
dispense water at intervals (one cup at a time). Press
the button (4) again to stop brewing, then close the knob
(7).
•
(Fig.4B)
- During each interval allow the descaling
solution to sit for about 10-15 minutes, switching off the
machine by means of the power button (2). Empty the
container.
•
(Fig.2)
- When the descaling solution is
fi
nished, remove
the water tank, rinse and
fi
ll it with fresh drinking water.
•
(Fig.3; Fig.5)
- Re-insert the tank into its housing. Open
the knob (7) and press the button (4) to empty 2/3 of the
water. Press the brew button (4) again and close the
steam knob (7) clockwise to stop dispensing.
• Let the machine warm up and empty the water tank as
described above.
If you are using a descaling product other than
the one recommended, it is important that
you carefully follow the manufacturer’s instructions
detailed on the package of the descaling product.
11 MACHINE DISPOSAL
• Put unused appliances out of service.
• Disconnect the plug from the socket and cut the electrical
cord.
• At the end of its life, take the appliance to a suitable waste
collection site.
This product complies with EU Directive 2002/96/EC.
The symbol
on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical
and electronic equipment.
By ensuring this product is disposed of correctly, you will
