Sachtler Reporter LED, Руководство пользователя

Страница: 6 / 36

Benutzerinformation Reporter LED
- 1 -
1 Safety instructions
Do not use the Reporter LED in water!
Ensure that during the operation of the light that enough
clearance is maintained around the fixture that the heat
it generates can dissipate.
The light housing may not be covered with any material,
as this causes a reduction in the cooling, which will
cause a reduction of the LED life.
Handle with care! Do not dispose of fixture in the trash!
Note: An input voltage higher than 33 V will destroy the
electronics inside the light fixture!
2 Properties
The Sachtler Reporter LED is designed for use as on-
board camera light.
The LED light fixture can be operated on low voltage
ranging from 6 VDC until 24 VDC. The integrated electronic
assembly drives the LED with the necessary current.
The standard power cable has a 2 pin Anton/Bauer Power
tap connector. There are other optional adapter cables
available to make it usable with other power sources (see
Accessories, chapter 7).
Due to its small and very robust construction, the Reporter
LED can also be used outdoors in harsh environments.
The front part of the housing is water resistant. Cover the
back side of the housing (switch and dimming knob) with
plastic bag and it can be used in wet conditions.