Sabo 92-14 HF, Инструкция по эксплуатации, Страница: 8 / 56

8
ENGLISH
GB
- do not cut wet grass.
- cut twice (with different cutting heights) if
the grass is long.
SERVICE AND MAINTENANCE
PREPARATIONS
Unless otherwise stated, all service and mainte-
nance must be carried out on a stationary machine
when the engine is not running.
Prevent the machine from rolling by al-
ways applying the parking brake.
Disengage the drive to the accessories,
shut off the engine and disconnect the
spark plug cable or remove the starter
key.
LUBRICATION
The deck arms are equipped with grease nipples
(fig. 8).
Lubricate these after every 25 hours of operation
(or at least once per season) with universal grease.
MAINTENANCE TIPS
To make cleaning and maintenance easier, the cut-
ting deck can be folded up:
1. Set the cutting height setting to the maximum
cutting height.
2. Lift the left-hand rear edge of the deck with one
hand (fig. 9).
3. Push up the catch and release the rear edge of the
deck (fig. 9).
4. Repeat the procedure on the other side.
5. Secure the tensioning arm on the hook.
6. Force the belt off the machine’s pulley.
7. Fold up the deck to the vertical position (fig. 10).
When the deck is folded down to working position,
ensure that the catch drops down into position
when the rear edge of the deck is lifted up (fig. 4).
CLEANING
After each use, the underside of the cutting deck
should be rinsed off.
If the grass has dried solid, scrape clean the under-
side.
If necessary, touch up the underside with paint to
prevent corrosion.
BLADES
Use protective gloves when changing
blades to avoid cutting yourself.
Ensure that the blades are always sharp. This pro-
duces the best cutting results.
Always check the blades after a collision. If the
blade system has been damaged, defective parts
should be replaced.
Always use genuine spare parts. Non-
genuine spare parts can entail a risk of
injury, even if they fit the machine.
Install the blades according to fig. 11 where the
blade edge is marked. The folded-up edge of the
blade should be positioned inwards towards the
blade holder.
The cutting system comprises two blade bars with
two replaceable blades Y (fig. 12). When replacing
blades, both should be replaced to avoid imbal-
ance.
Install the new blades. Tighten screws V and W
properly. Tightening torque: V - 9.8 Nm, W - 24
Nm.
POSITIVE DRIVE BELT
Both blades are powered inside the deck by a pos-
itive drive belt.
If one of the blades has struck a solid object (e.g. a
stone), the belt tension may be altered. This can
lead to the positive drive belt ‘over-meshing’
which, in the long term, can damage the blades.
Following a powerful collision, always
check that both blades are at right-an-
gles to each other (fig. 11).
The working areas of the blades overlap each oth-
er. If the blades’ position in relation to each other
has been altered, there is a considerable risk of the
blades striking each other. This can entail serious
damage to the cutting deck.
If this is the case, take the machine and cutting
deck to a service workshop for repair and inspec-
tion.