Sabo 102-13G, Инструкция по эксплуатации

Страница: 100 / 323

Access for making this adjustment is by taking off the inspection hatch beneath
the seat.
Loosen the locking nuts (2) and tighten or loosen the screw (1) as much as
necessary for a length “A” of the spring (3) of:
A = 114 - 116 mm ( For mechanical drive models)
A = 109 - 111 mm ( For hydrostatic drive models)
measured to the outside of the end of the
spring. When the adjustment has been made,
tighten the nuts (2).
When replacing the belt,
take great care when using for the first few
times as engagement may be sudden until
the belt is sufficiently run in.
6.3.6 A
DJUSTMENT OF THE SPRING OF THE PAWL FOR HOOKING THE GRASS
-
CATCHER
If the grass-catcher tends to jump about and to
open up when going over rough ground, or if it has
difficulty in hooking back on after being emptied,
the tension of the spring will need to be adju-
sted(1).
Change the hooking point by using one of the holes
(2) until the required result is achieved.
NOTE
➤
➤
ENG 45 MAINTENANCE
2
A
1
3
1
2