Sabiana UP-ECO, Руководство по эксплуатации

Страница: 38 / 116

38
English
ELECTRICAL CONNECTIONS
COMPLY WITH THE
CORRECT CONNECTION
SEQUENCE
The control panel must be electrically connected to
the power board located inside the device electrical
equipment, respecting the correspondence of the
numbering common to both boards.
Use 3 leads with 0.5 mm² section.
NOTE: The length of the connection cable must not
exceed 20 metres.
L = max 20m
5 6 7
1
2
KD2
MC4
MC2
M3 M2 M1
D+
0 7 6 5 6 0
D-
10V
0 5
DI1
EVO
POWER UNIT
ELETTRONIC
POWER BOARD
CFF
° C
IAQ
AUTO
AUTO
USE OF THE CONTROL
On/Off (Fig. "A"):
• By pressing the ON/OFF button the control is
switched on.
• Pressing the ON/OFF button again the control is
switched off.
° C
IAQ AUTO
AUTO
Fig."A"
Setting the Setpoint (Fig. "B"):
• Use the knob to set the desired temperature value.
The red LED "
2
" lights up when required; it stays off
when the temperature is reached.
The flashing of the LED indicates an alarm
°
C
IAQ AUTO
AUTO
2
Mode selection (Fig. "C"):
• Press the indicated button to select the desired
operation mode:
- the cooling function is set.
- the heating function is set.
- the ventilation-only function is set.
A signalling LED is assigned to each mode; the LED
lights up to identify the selected mode.
° C
IAQ AUTO
AUTO
AUTO
Fig."C"
Fig."B"