CAUTION
Putting out grease fires by closing the lid is not
possible. Side burners are well ventilated for safety
reasons.
Do not use water on a grease fire. Personal injury
may result. If a grease fire develops, turn knobs and
gas valve off.
Do not leave side burner unattended while reheating
or burning off food residue on HI. If side burner has
not been regularly cleaned, a grease fire can occur
that may damage the product.
CAUTION
WARNING
Turn controls and gas source OFF when not in use.
If ignition does NOT occur in 5 seconds, turn the
control knobs OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
WARNING
Outdoor gas appliance is not intended to be installed in
or on a boat.
Outdoor gas appliance is not intended to be installed in
or on an RV.
Never attempt to attach this side burner to the self-
contained gas system of a camper trailer or motor
home.
Do not use side burner until leak-tested.
If a leak is detected at any time, STOP and call the fire
department.
If you cannot stop a gas leak,
immediately
close gas
valve and call gas supplier or your fire department!
USE AND CARE
DANGER
Do not insert any tool or foreign object into the valve
outlet. You may damage the valve and cause a leak.
Leaking gas may result in explosion, fire, severe personal
injury, or death.
Side Burner Ignitor Lighting
Do not lean over side burner while lighting.
1. Turn
OFF
all control knobs.
2. Turn
ON
gas at source.
3.
Open side burner lid during lighting
.
4. To ignite push in and turn side burner control knob to .
5. Push and hold
ELECTRONIC IGNITION
button until the burner
lights.
6. If ignition does
NOT
occur in 5 seconds, turn the control knobs
OFF
, wait 5 minutes, and repeat the lighting procedure.
7. Repeat steps 4 through 6 for second burner.
Side Burner Match-Lighting
Do not lean over side burner while lighting.
1. Turn
OFF
all control knobs.
2. Turn
ON
gas at dource.
3.
Open lid during lighting.
4. Place lit match near burner.
5. Push in and turn control knob of the burner you are lighting
to the position. Ensure burner stays lit.
6. Light adjacent burner by pushing
knob in and turning to the position.
4