Install-TOMMI - JUN_2020 - 2020-06-18.docx www.yunca.co.nz
Page 1 of 15
A division of Terry Young Ltd, New Zealand
INSTALLATION INSTRUCTIONS for
TOMMI
WOOD BURNER
• Clean Air Sub 0.6 g/kg • Non Clean Air (Rural).
JUNE 2020
TESTED in compliance with AS/NZS 2918: 2001 by Spectrum Laboratories Limited
SAFETY INFORMATION
GENERAL:
•
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
•
For the protection of young children, install an effective fire safety screen around your fire.
Always keep children well away from the wood burner when it is alight.
•
Supervise young children to ensure they do not play with the appliance.
•
During initial burns of the appliance, ventilate the rooms well. It is recommended that
babies, small children, pregnant women and pets should not be present in the area during
initial burns, as this is the firebox paint curing period.
•
Do not make any modifications to the unit. Use it only in the manner described in the
Operations Manual. Using it in any manner not recommended by the manufacturer may
result in injury or death.
FOR UNITS INCLUDING ELECTRICAL CONNECTIONS:
•
If the wood burner is permanently connected to an electrical source, an isolating switch
(wall switch) must be installed.
•
New circuits or modifications may be made, if required, but must be made using the
services of a certified electrician only.
•
Ensure that the outlets you use are grounded properly, polarised and provided with fuse
units.
•
Ensure that the electrical plug is accessible after installation. The wood burner must not
be located immediately below an electrical socket. The socket should be located to one
side of the wood burner. The electrical outlet should not be installed higher than 300mm
maximum from the floor to the top of the plug socket outlet cover plate.
•
Never operate the appliance with a damaged plug or cord. If you observe the fan unit is
malfunctioning or the heater has been damaged in any way, call the authorised service
person immediately for repairs, or to make electrical or mechanical adjustments. Isolate
the electrical supply in order to alleviate any potential risk.
•
If the supply cord is damaged, the manufacturer, its service agent or a suitably qualified
person must replace it in order to avoid electrical hazard. Any cord similar to the original
can be used.
