A. Water Softener
The water softener must be set manually, using the water
hardness dial.
The water softener is designed to remove minerals and salts from
the water, which would have a detrimental or adverse effect on
the operation of the appliance.
The higher the content of these minerals and salts, the harder
your water is.
The softener should be adjusted according to the hardness of the
water in your area. Your local Water Authority can advise you on
the hardness of the water in your area.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the
amount of salt consumed based on the hardness of the water
used. This is intended to optimise and customise the level of salt
consumption.
Please follow the steps below for adjustment in salt
consumption.
1. Open the door, Switch on the appliance;
2. Press the Program button for more than 5 seconds to start
the water softener set model within 60seconds after the
appliance was switched on (The Salt and Rinse aid warning
lights will be on periodically when it get in the set model);
3. Press the Program button to select the proper set according to
your local environment, the sets will change in the following
sequence: H3->H4->H5->H6->H1->H2->H3;
77
GB
