Socket Head Cap
Screw M3x8mm
(HC050-S)
M3 Head Screw
Socket Head Cap
Screw M3x8mm
(HC050-S)
Finishing
Washer M3
(H0007-S)
Finishing Washer M3
(H0007-S)
MOTOR BELT TENSION
*Fit the motor assembly into position.
*Move it to the minimum centre distance.
*First put the belt on the motor pinion.
*Then put the belt around the big pulley.
*Rotate the motor several times by hand.
*Pull on the motor mount to tension the belt.
*Rotate again the motor several times by hand.
*Provide the correct force, and properly tension the belt.
*Tighten the M5 nuts first, then the (2) M3 screws later.
You can use a 4-5mm shaft as a lever to set proper
motor belt tension.
BAG20
Motor Belt
(HC535-S)
Page 30
INSTALLATION OF THE MOTOR
