12 832 516 15
Saab 9-3 CV M04-
45
Cars without telematics unit in the centre of
the torsion compartment:
Disconnect the
battery negative cable. Locate the loose fibre
optic cable and the connector with the fibre optic
cables connected at the left-hand lower A-pillar
(taped to the cable duct) and lift up the connec-
tor's lock tab.
46
Cars without telematics unit in the centre of
the torsion compartment:
Remove the fibre
optic cable from the position in the connector
where the arrow points outward, to the fibre
optic cable.
47
Cars without telematics unit in the centre of
the torsion compartment:
Remove the protec-
tive cover from the connection to the kit's fibre
optic cable.
48
Cars without telematics unit in the centre of
the torsion compartment:
Fit the protective
cover to the connection of the fibre optic cable
that was removed, carefully guide the fibre optic
cable away so that it is not damaged and position
it behind the wiring harness.
49
Cars without telematics unit in the centre of
the torsion compartment:
Fit the connection
on the new fibre optic cable in the connector and
fit the lock tab.
WARNING
The visible red light is a class 1 laser. Do not look
directly into the optical fibre or the control module
connector when in close proximity to them. The
eyes can be damaged if the distance between the
light source and the eyes is less than 20 mm.
F930A271
45
48
45
49
Important
Handle the fibre optic cables with care or the signal
may be distorted.
•
It is very important that the two cables in the
connector are not mixed up.
•
Do not bend the cable in a radius smaller than
25 mm.
•
Keep the cable ends free from dirt and grime.
•
The cable should not lie against any sharp
edges as this may cause increased signal
reduction.
