JFK Product & Installation Instructions #8920100 Feb 2, 2015
Pg. 11
3.
On the top surface of each Base Assembly, there are two (2) holes that
reveal the anchor holes; if the plastic caps have been installed they must be
removed to get access to the anchor holes. (FIG 2)
Caution: Safety glasses to be worn during Drilling, Anchor installation & setting!
4.
Drill the 4 holes for the floor anchors using the anchor holes in the 2 Base Assemblies as guides (FIG 1).
Drill the holes 5/8” diameter to a depth equal to the length (2 inches) of the floor 1/8”.
Note: Refer to Page 9 for complete instructions on proper installation of Floor Anchors!
5.
Move the apparatus aside. Vacuum the holes to remove all dust and concrete chips.
6.
Insert the floor anchors, threaded end up & slotted end down, into the drilled holes. Ensure the top of the
floor anchor is flush with or just below the top of the concrete.
7.
Set each of the floor anchors by striking the plunger in the center of the floor anchor as per Page 9.
Note: Ensure that the anchors are properly set or the safe use of the equipment may be
compromised!
8.
Reposition the apparatus over the floor anchor and bolt down the Base Assemblies (see FIG 1) loosely.
Ensure that Base assemblies are Parallel to each other and install 1 or 2 “JFK” upright assemblies (355-05)
on to the 2 Bases (355-01), this will assist in maintaining the correct width between the bases as well as
maintaining them parallel to each other.
9.
Now that the uprights are installed, tighten the bolts down on the bases securely.
10.
Install the plastic caps in the indicated holes shown in FIG 2 of the top of the Base Assemblies.
Just for Kids - (355-CS) Complete System Base Assembly Tie-Down
•
Requires (1) 4-Station Circuit Base (355-154) & (4) Single Base Assemblies (355-01).
S/A Sport recommends that the 4 Station Circuit Base & base
Assemblies be bolted to the floor. They have been designed
and supplied with the required hardware for bolting to a
concrete floor.
This procedure will require at least two (2) qualified
persons. Children or other unqualified personnel
should at no time undertake any part of this
procedure.
1.
Position the 4 Station Circuit Base (355-154) in the center
of the desired location for the apparatus to be set up. The
complete 4-station circuit uses a floor area greater then 17
feet x 17 feet square.
2.
Position the 4 Base Leg assemblies (355-01), around the 4 Station Circuit Base, as shown in FIG 4 on the
next page. Ensure that the numbers on the side of the bases, the adjustment scale face away from centre.
