355 JUST FOR KIDS
Assembly Instructions
Page 22 of 25
6. Position the Ring Frame Assembly at a height that will be comfortable to work
with during the set-up of the apparatus and engage the Snap Lock Devices so
that the pin drops into a hole. Tighten the Spin Lock portion securely by
turning it clockwise.
7. Repeat Steps 4 through 6 with the second Just for Kids Ring Frame.
8. Locate the Just for Kids set of Rings (#355-110).
9. Open the quick links on each Just for Kids Ring and mount them to the Ring
Frame. Close the quick links securely. (See Fig. 14)
2.9. Changing Just for Kids Apparatus Configurations
Simply by changing the combination of Just for Kids Uprights placed between the SA Sport Just for
Kids Bases, you can create numerous Apparatus Configurations (See Chart on page 7).
This procedure will require at least two (2) qualified persons. Children or other
unqualified personnel should at no time undertake any part of this procedure.
1. To install or remove the Just for Kids Uprights on the bases, completely loosen the Clamp on both
sides of one of the Upright Assemblies by turning Counterclockwise direction.
2. Carefully lift an Upright Assembly onto or off the bases. Always adjust the distance between the
Just for Kids Bases so that the inside surfaces of the upright clamp mechanisms are tight to the
Bases.
Ensure that the Upright Assemblies remain square & perpendicular to the Bases after
adjusting their location on the bases.
3. Lock the Uprights in place by tightening the Clamp handle and spinning it in a clockwise direction.
4. If you are assembling a Just for Kids Parallel Bars or Uneven Bars, repeat steps 1 through 3 with
the second Just for Kids Upright.
2.10. Equipment Height Adjustment
SA Sport recommends that two (2) qualified persons perform this adjustment. At no
time should children or other unqualified persons perform equipment height
adjustments.
1. To avoid possible injury and/or damage to the equipment, support the Rail or Ring Frame during
all Adjusting Tube height adjustments.
To avoid injury while adjusting Ring Frame or Rail height, keep hands well clear of the
Adjusting Tubes where they slide into the Uprights.
Fig. 14
