355 JUST FOR KIDS
Assembly Instructions
Page 19 of 25
2.7. Just for Kids Rail & Adjusting Tube Assembly to Uprights Assembly
This procedure will require at least two
(2) qualified persons. Children or other
unqualified personnel should at no time
undertake any part of this procedure.
1. Locate one (1) Just for Kids Upright Assembly
(#355-05).
See Page 9, Pre-assembly of Just for
Kids Uprights, if this step was missed.
2. Install the Just for Kids Upright between the
Bases (refer to section on Bases Tie-Down if
required) and tighten the clamp (Fig. 11) on the
lower section of each side of the Upright
Assembly by turning Clockwise.
Mounting the Upright Assembly on to the Bases must be done at this time in order to
prevent the completed assembly from toppling over.
3. Loosen the Spin-Snap Lock on each side of the Upright Assembly by turning the Spin Lock
portion, round disc, counterclockwise. Turn the handle counterclockwise until it stops, but do not
force it any further. This stop prevents the Spin Lock from being removed.
4. Loosen the 3/8” Flat Head Screw which link the uprights to
the base tube.
3/8” FLAT
HEAD SCREW
BASE TUBE
UPRIGHT END
CONNECTION BLOCK
Fig. 11
