10
Locking Plate Assembly
- The battery pack can be secured to the mounting plate using the provided
lock plate assembly. To install open the lock plate so that the bottom tabs are moved close to one another
to allow the lock plate to be inserted into the slots on the mounting plate secured to the lift. Close the lock
plate assembly so that the tabs are captured by the slots. Insert a padlock (not provided) through the
holes on the lock plate assembly to secure it.
Hand Control -
The four button unit controls all lift movements. The arrows indicate direction of
movement. Control is fully waterproof and meets IP67 standards.
Mast -
This vertical piece is bolted to the base assembly.
Actuator -
Attached to mast, it powers the
lift’s up and down movements.
Rotation Motor Assembly -
Mounting plate, 24-volt motor, and small gear.
Hub Assembly -
Hub, bearings, shaft, large gear and mast mounting plate.
Horizontal Support Arms -
These two support arms connect the mast to the seat
support arm. The longer horizontal support arm (actuator arm) connects to the actuator
and initiates lifting movements.
Seat Arm -
Connects the seat to the horizontal support arms.
Seating System
–
The seat is manufactured from roto-molded plastic with a stainless steel frame. The
seat comes standard with a seatbelt. The seatbelt must be used during each use. It is recommended that
the seat be rinsed off with fresh water between each use and cleansed daily with a disinfectant solution of
1:100 dilution of household bleach to fresh water and then rinsed with fresh water. In the event of a
contamination incident such as patient/user excreta - cleanse seat and seatbelt immediately with the
above disinfectant solution. Do not use seatbelt if it is damaged or becomes worn.
Armrests are included as a standard item on all S.R. Smith lifts. The armrests are designed so they can
be rotated up out of the way during transfer.
This lift seat assembly is designed to be used exclusively with S.R. Smith aquatic access lifts.
UNPACKING & ASSEMBLY INSTRUCTIONS
REFER TO DIAGRAM (page 23) FOR PARTS IDENTIFICATION.
READ THESE INSTRUCTIONS IN THEIR ENTIRETY BEFORE UNCRATING PAL2
Prior to opening pallet, inspect external condition for any visible damage. It is important that any
damage be noted on the Bill of Lading. Immediately notify S.R. Smith or your Authorized Reseller
of missing or damaged parts.
4-Button Hand
Control
