S.R.Smith aXs Series, Руководство пользователя и процедуры технического обслуживания

Страница: 7 / 22

700-3000 6.21.2016 7
Base Assembly - Mounts to the pool deck contains the turning elements of the lift.
Base Insert Stem - Slides into the anchor sleeve that is installed on the pool deck.
Mast -
The main vertical component of the lift.
Actuator Arm - Primary lifting arm of the lift connects the mast to the seat arm and is raised by the
attached actuator.
Support Arm - Provides stability for the seat arm.
Seat Arm - Provides an attachment point for the seat assembly and nests inside the actuator arm to
avoid pinch points.
Housing - ABS plastic cover with an acrylic cap shields base assembly components from weather. When
cleaning the housing, be sure to use a clean, soft, non-abrasive material.
Actuator - Provides the up and down lifting action.
Rotation Motor Assembly – Consists of a mounting plate, 24-volt motor and small gear.
Control Box - The LiftOperator is available with an optional Activation Key feature that provides a higher
level of security by allowing control operation only with the use of the activation key. The unit controls all
lift operations identical to the user hand set. Three cables connect to the bottom of the Control Box to
enable operation of the lift. The largest connector is for the hand control. Connector # 1 is for the motor
cable (red stripe). Connector # 2 is for the actuator cable (green stripe).
Touchpad Control –
The touchpad control arrow keys can be used in the
event that the hand control is out of reach or fails.
Simply press and hold the arrow for the desired
action for one movement at a time – Up, Down, Left,
Right Releasing the Arrow stops movement.
Battery Level LED Indicators –
The Battery Level LED Indicators show battery
charge levels. The LED’s will illuminate when either
the touchpad control or the hand control is activated
and will stay lit for 10 seconds. At greater than 50%
the LED glows Green, at less than 50% the LED
glows Amber, and less than 25% the LED glows red
and indicates the battery requires charging. If the
less than 25% LED glows red, do not operate the lift.
Remove the battery and fully charge before use.
Service Required LED –
The Service Required LED will illuminate when the battery pack has been removed/replaced 120
times - approximately once every 4 months. This indicates that required maintenance for the lift
must be completed. Please see the maintenance section of the Lift Owner’s Manual for the
requirements. The Service Required LED can be reset by inserting a standard FAT-formatted
USB mass storage device (not included) into the USB Port on the bottom of the controller
. When
CONNECTOR 1
(MOTOR CABLE)
CONNECTOR 2
(ACTUATOR CABLE)