DT Etherlink IV
User Manual
- 47 -
4.6
Commands
4.6.1 Main Menu
The main menu is presented as shown below:
MODEL SA-DT-ETH-2DSL-2Eth
HW 1.2
SW 1.0.0
DATE 10-11-2009
ID
RUNS 0d 00:45:59
ALARM URGENT
STATUS LINK DOWN
MODEL_DESC Standalone Dual xDSL/Dual E1/Dual Ethernet 120 Ohm
IP 192.168.0.235
------------- Main Menu -----------------
1. Performance management (PM)
2. Fault and maintenance management (FMM)
3. Configuration management (CM)
5. Exit
-----------------------------------------
Select [1..5]
CO_MM>
To select the desired sub-menu, type
the appropriate number from “1” to “5” and press <enter>.
4.6.1.1 System Invitation
The following format of the system invitation is used in all menus:
<
cc
>_<
addr
>_<
sf
>>
сс
is the device mode:
RR - Regenerator
CO
– Master
CP
– Slave
CX
– Modem with both types of modes (MASTER and SLAVE)
CA
– Device with automatic selection of the DSL line parameters (MASTER, BASERATE,
PAM and ANNEX)
addr
is the address of:
Regenerator in the system (only for Regenerators)
LTU device in the subrack (slot number, only for subrack LTU devices)
sf
is the short form of the current menu:
MM
– Main Menu
PM
– Performance Management
FMM
– Fault and Maintenance Management
CM
– Configuration Management).
For example: CO_PM>
means the device is in the Master mode and we are in the Performance Management menu.
