![background image](http://html1.mh-extra.com/html/ryobi/p2805/p2805_operators-manual_1504981012.webp)
10 — English
MAINTENANCE
WARNING:
To avoid serious personal injury, always remove the bat-
tery pack from the tool when cleaning or performing any
maintenance.
WARNING:
Always wear eye protection with side shields or goggles
marked to comply with ANSI Z87.1. Failure to do so could
result in fluids entering your eyes resulting in possible
serious injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken, or destroy plastic which may result
in serious personal injury.
CLEANING THE UNIT
See Figure 6.
WARNING:
Always store and dispose of chemicals properly. Disposal
of contaminated rinse water should be performed accord-
ing to local ordinances and bylaws.
Draining the tank
:
If there is any liquid left in the tank after spraying, the tank
should be drained before cleaning. Do not store chemicals
in the tank.
Remove the battery pack.
Unscrew the cap and remove it from the tank.
Drain the contents of the tank through the fill area.
NOTE:
Drain the contents back into the original container
or a suitable replacement container. For disposal, follow
instructions on the product’s label and all local, state,
and federal regulations.
Cleaning the fogger:
Fill the tank about one-third full with clean water. A small
amount of mild household detergent may be added.
NOTE:
Never use flammable chemicals or abrasive
cleaning agents to clean the tank.
Replace the tank cap and tighten securely.
Reinstall the battery pack. Spray until the tank has been
emptied. Make sure to direct the spray toward an area
that will not be damaged by the spray solution.
Refill and repeat the procedure with clean water. It may
be necessary to rinse the tank more than once, then drain
again as directed above.
Allow all pieces to completely dry, then reinstall the tank
cap.
Wipe the outside of the fogger with a clean, dry cloth.
Содержание P2805
Страница 3: ...iii Fig 5 Fig 6 ...