![background image](http://html1.mh-extra.com/html/ryobi/jm80/jm80_owners-operating-manual_1505789018.webp)
Page 18
Fig. 26
MAINTENANCE
BLADE REPLACEMENT
See Figures 24-27.
After extended use, the blade on your plate joiner may
become dull and need replacing. If you accidentally hit a
nail or other blunt object, it will break the carbide tips on the
blade. These situations also require replacing the blade.
HOW TO REPLACE THE BLADE
1.
Unplug your plate joiner.
2. Remove dust bag.
3. Place your plate joiner upside down on a workbench as
shown in figure 24.
4. Using a screwdriver remove the two screws securing
front base assembly.
5. Pull adjustable fence in the direction shown by the arrow
in figure 24 and remove front base assembly.
6. Using a pair of needle nose pliers, stretch and release
springs from tabs on bearing plate.
See Figure 25.
7. Push adjustment rod away from bearing plate and remove
rear base assembly.
8. With base assemblies removed, place plate joiner upside
down on a workbench as shown in figure 26.
9. Place a #2 Phillips screwdriver or 1/4 in. diameter pin in
one of the two holes provided in bearing plate.
10. Place one of the non-cutting teeth located behind each
carbide tipped cutting tooth against the screwdriver or
pin and lock blade preventing it from rotating.
DO NOT
lock blade against one of the cutting teeth. Carbide
tips will break.
11. Using a 3/16 in. wrench, remove blade screw.
NOTE:
Turn blade screw counterclockwise to remove.
See
Figure 27.
12. Remove outer blade washer and blade.
13. Clean wood particles and resin from blade washer, dust
bag area, base assembly slots, and all surrounding parts.
14. Place inner blade washer on gear spindle.
See Figure
27.
15. Place new blade onto shoulder of blade washer and
secure with outer blade washer and blade screw.
NOTE:
Blade screw fits into cupped side of outer blade
washer.
WARNING:
Failure to unplug your plate joiner could result in accidental
starting causing possible serious personal injury.
WARNING:
If inner blade washer has been removed, replace it
before installing new blade. Failure to do so could cause
an accident since blade screw will not tighten properly.
#2 PHILLIPS SCREWDRIVER
OR 1/4 IN. DIAMETER PIN
CARBIDE TIPPED
CUTTING TOOTH
BEARING
PLATE
NON-CUTTING
TOOTH BEHIND
CARBIDE TIPPED
CUTTING TOOTH
Fig. 25
BEARING
PLATE
ADJUSTMENT ROD
BLADE
TAB(S)
SPRING(S)
NOTCH
Fig. 24
SCREWDRIVER
SHOWN WITHOUT DUST BAG
ADJUSTABLE
FENCE
SCREW
HOLE
TO
REMOVE
FRONT BASE
ASSEMBLY