Ryobi HLCS01, Руководство оператора

Страница: 26 / 88

26 – English
RESTORE ORIGINAL
SHAPE BY ROUNDING
THE FRONT
LUBRICATING HOLE
MAINTENANCE
FIG. 41
FIG. 42
INCORRECT TOP PLATE FILING
ANGLE
MORE
THAN 30°
LESS
THAN 30°
30°
CORRECT TOP PLATE
FILING ANGLE
INCORRECT SIDE PLATE
FILING ANGLE
BACKWARD
SLOPE
HOOK
80°
CORRECT SIDE
PLATE FILING
ANGLE
FIG. 38
FIG. 39
FLAT FILE
DEPTH GAUGE JOINTER
FIG. 40
SIDE PLATE ANGLE
See Figure 39.

CORRECT - 80° Produced automatically if
correct diameter file is used in file holder.

HOOK - “Grabs” and dulls quickly. Increases
potential of KICKBACK .
Results from using a file with diameter too small,
or file held too low.

BACKWARD SLOPE - Needs too much feed
pressure, causes excessive wear to bar and
chain.
Results from using a file with diameter too large,
or file held too high.
DEPTH GAUGE CLEARANCE
See Figures 40 - 41.
 The depth gauge should be maintained at a
clearance of .025 in. Use a depth gauge tool
for checking the depth gauge clearances.

Every time the chain is filed, check the depth
gauge clearance.
Use a flat file and a depth gauge jointer to lower
all gauges uniformly. Depth gauge jointers are
available in .020 in. to .035 in. Use a .025 in. depth
gauge jointer. After lowering each depth gauge,
restore original shape by rounding the front. Be
careful not to damage adjoining drive links with
the edge of the file.
Depth gauges must be adjusted with the flat file in
the same direction the adjoining cutter was filed
with the round file. Use care not to contact cutter
face with flat file when adjusting depth gauges.
MAINTAINING THE GUIDE BAR
See Figure 42.
CAUTION:
Make sure the chain has stopped and the bat -
tery pack has been removed before you do any
work on the saw to avoid possible injury.
Proper maintenance will maximize the useful life
of the guide bar.
Each day of use:
Clean the bar and check for wear and damage.
Feathering or burring of the bar rails is a normal
process of bar wear, but such faults should be
smoothed with a file as soon as they occur.