Ryobi HLCS01, Руководство оператора

Страница: 22 / 88

22 – English
WARNING:
Never touch or adjust the chain while the
motor is running. The saw chain is very sharp;
always wear protective gloves when performing
maintenance to the chain to avoid possible
serious lacerations.
CAUTION:
Always wear gloves when handling the bar and
chain; these components are sharp and may
contain burrs.
NOTE: When replacing the guide bar and chain,
always use the specified bar and chain listed in
the
Bar and Chain Combinations
section later
in this manual.

 Remove the battery pack before you do any
work on the chain saw.

 Remove the bar mounting nuts using the com -
bination wrench provided.

 Remove the chain cover.


Remove the bar and chain from the mounting
surface.


Remove the old chain from the bar.

 Lay out the new saw chain in a loop and
straighten any kinks. The cutters should face
in the direction of chain rotation. If they face
backwards, turn the loop over.

 Place the chain drive links into the bar groove
as shown.
NOTE: Make certain of direction of chain.


Position the chain so there is a loop at the back
of the bar.

Hold the chain in position on the bar and place
the loop around the sprocket.

Fit the bar flush against the mounting surface
so that the bar studs are in the long slot of the
bar.

Replace the chain cover ensuring that the ad -
justing pin in the chain cover is in the bar chain
tensioning pin hole and that both bar studs are
securely in their respective holes in the chain
cover.
NOTE: The adjusting pin may need to be slight -
ly repositioned with the chain tensioning screw
so that it is aligned with the position of the bar
chain tensioning pin hole.
MAINTENANCE
CHAIN DRIVE LINKS
CUTTERS
CHAIN ROTATION
BAR
GROOVE
CHAIN DRIVE
LINKS
CHAIN
TENSION PIN
HOLE
ADJUSTING
PIN
BAR STUDS
BAR
MOUNTING
NUTS
CHAIN
COVER
FIG. 26
FIG. 27
FIG. 28