4
DESCRIPTION
1. Spindle lock button
12. Depth lock knob
2. Hex-head bolt
13. Base plate
3. Spanner
14. Depth of cut
4. Outer blade washer
15. Depth scale
5. Lower guard
16. Bevel adjustment knob
6. Lower guard lever
17. Bevel scale
7. Upper guard
18. Trigger switch
8. Blade
19. Safety button
9. Inner blade washer
20. Line guide
10. Dust port
21. Depth adjustment lug
11. Riving knife
22. Livetool Indicator
TM
SPECIFICATION
Input
1,250 W
No load speed
4,500 min
-1
Bore size
16 mm
Blade size
190 mm
Cutting capacity
at 0
0
66 mm
at 45
0
38 mm
Bevel scale
0 - 45
0
Cord length
4 m
INSTRUCTIONS FOR SAFE HANDLING
The maximum permissible system impedance: Zmax for
ECS12519 is 0.245 Zref.
If in doubt, please verify with your local energy-utility that
the AC outlets in your area do not exceed the above
values.
STANDARD ACCESSORIES
Saw blade, Parallel fence, Spanner.
APPLICATION
Sawing wood.
NOISE BUILD-UP
Noise (sound pressure level) in the workplace can
exceed 85 dB. In this case, sound insulation and
hearing protection measures must be taken by the
operator.
ASSEMBLY INSTRUCTIONS
Be sure to disconnect the tool from the power
supply before attaching or removing the saw
blade. Be sure that the teeth of the saw blade are
pointing upward at the front of the tool.
ATTACHING AND REMOVING THE BLADE
(FIGURES 2, 3, 4, AND 5)
ATTACHING THE BLADE
1. Pressing the spindle lock button (1), turn the hex-head
bolt (2) with the spanner (3) until the spindle locks.
(Fig.2)
2. Loosen the hex-head bolt by turning the spanner
anticlockwise while pressing the spindle lock button.
(Fig.2)
3. Remove the hex-head bolt and the outer blade washer
(4). (Fig. 2)
4. Retract the lower guard (5) back with the lower guard
lever (6) as far as possible under the upper guard (7).
(Fig. 3)
5. Then, attach the saw blade (8) against the inner blade
washer (9) on the spindle. Then fit the outer blade
washer and the hex-head bolt. (Fig. 3 and 4)
6. Press the spindle lock button again, tighten the hex-
head bolt by turning the spanner clockwise while
pressing the spindle lock button. (Fig. 5)
7. After tightening the hex-head bolt, release the spindle
lock button.
REMOVING THE BLADE
1. Pressing the spindle lock button, turn the hex-head
bolt with the spanner until the spindle locks.
2. Loosen the hex-head bolt by turning the spanner
anticlockwise while pressing the spindle lock button.
3. Remove the hex-head bolt and the outer blade
washer.
4. Retract the lower guard back as far as possible under
the upper guard, then remove the saw blade.
ADJUSTING THE RIVING KNIFE (FIG. 6)
WARNING
Do not use saw blades the disk of which is
thicker or the set of which is smaller than the
thickness of the riving knife.
ECS12519-Eng.qxd 10/15/04 2:59 PM Page 4
