Ryobi CMS1825, Руководство по эксплуатации для владельца

Страница: 8 / 15

Page 8
■
SQUARING THE BLADE TO THE MITRE TABLE
Pull the saw arm all the way down and engage the lock down
pin to hold the saw arm in the transport position. (Fig 11)
Unlock the bevel lock knob and move the saw arm to the 0
position and lock the bevel lock knob. (Fig 12)
Lay the set square on the mitre table and against the blade and
if the blade and mitre table do not align adjust as follows.
(Fig 13)
Unscrew the 0° bevel positioning allen screw at the rear as
shown. (Fig 14)
Correctly align the blade and mitre table using the set square
and lock the bevel lock knob. (Fig 15)
Reset the 0° bevel positioning allen screw so where the saw
arm is moved to the 0° bevel position the allen screw bottoms
out and adjust the pointer to the 0° position (Fig 16)
■
SQUARING THE BLADE TO THE TABLE AT 45°
Repeat this procedure for squaring the blade to the mitre table
at 45° (Fig 17)
Move the saw arm to the 45° bevel position. (Fig 18)
Fig.11
Fig.12
Fig.13
Fig.14
Fig.15
Fig.16
Fig.17
Fig.18
0° Bevel Positioning
allen screw
45° Bevel Positioning
allen screw