Ryobi CMS1825, Руководство по эксплуатации для владельца

Страница: 13 / 15

Page 13
When cutting crown molding by this method the bevel angle
should be set at 33.85°. The mitre angle should be set at
31.62° either right or left, depending on the desired cut for the
application. See the chart below for correct angle settings and
correct positioning of crown molding on mitre table.
The settings in the chart below can be used for cutting all
standard crown moulding with 52° and 38° angles. The crown
moulding is placed flat on the mitre table using the compound
features of your mitre saw.
■
CUTTING WARPED MATERIAL
(See Figures 26 & 27)
When cutting warped material, always make sure it is
positioned on the mitre table with the convex side against the
fence as shown in figure 26.
If the warped material is positioned the wrong way as shown
in figure 27, it will pinch the blade near the completion of the
cut.
Bevel
Angle Type of Cut
Setting
Left Side, inside corner
1. Top edge of moulding against fence
2. Mitre table set right 31.62°
3. Save left end of cut
Right Side, inside corner
1. Bottom edge of moulding against fence
2. Mitre table set left 31.62°
3. Save left end of cut
Left Side, outside corner
1. Bottom edge of moulding against fence
2. Mitre table set left 31.62°
3. Save right end of cut
Right Side, outside corner
1. Top edge of moulding against fence
2. Mitre table set left 31.62°
3. Save right end of cut
33.85°
33.85°
33.85°
33.85°
RIGHT
Fig.26
WRONG
Fig.27
WARNING: To avoid a kickback and to avoid
serious personal injury, never position the
concave edge of bowed or warped material
against the fence.