Ryobi AP13AK, Руководство по эксплуатации для владельца

Страница: 9 / 14

ADJUSTMENT
Page 8
MAKING THE CUTTERHEAD AND WORKTABLE
PARALLEL (Fig. 9~12)
Plane a workpiece and measure thickness after the
cut. If the thickness is not the same on both sides of
the workpiece, perform the following action.
Adjust the cutter shaft and the worktable so they are
parallel. The tools used for checking are shown below
. Please use hardwood to make a tool guage block
according to the size shown in the figure 9. Make the
adjustments as per the following procedures.
Remove height adjustment handle and both top
and side covers by removing allen screws (Fig.11)
to expose height adjustment lock nuts. (Fig.12)
Loosen adjustment lock nut. (Fig.12)
Adjust height nut up or down as required to suit
guage block. (Fig.10)
When desired height setting is reached, tighten
lock nuts inposition. (Fig.12)
Reassemble side and top covers and replace
height adjustment handle.
34mm
135
° 33mm
100mm
3mm
15mm
70mm
100mm
120
°
30mm
20mm
33mm
5mm
Fig. 10
Fig. 9
Height Adjustment
Crank Handle
Allen
Screws
Fig. 11
Height
Adjustment Nut
Fig. 12