Ryobi AirStrike P360, Руководство оператора

Страница: 8 / 36

8 — English
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
APPLICATIONS
You may use this tool for the purposes listed below:

Finish and Trim (Interior and exterior)

Door & Window Casing

Door Jambs

Baseboard

Crown Molding

Cabinetry

Cap and Shoe Molding

Molding

Staircases

Door and Window Trim

Chair Rail

Brickmold

Hardwood Flooring

Paneling

Furniture
ATTACH BELT HOOK
See Figure 1, page 12.
The belt hook can be installed on the left or right side of the
stapler, depending on operator preference.
 Align belt hook and screw with right or left side screw
hole.

Using a phillips screwdriver (not included) tighten se-
curely.
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 12.

To install,
place the battery pack in the tool. Align the
raised rib inside the tool with the groove on the battery
pack.

Make sure the latches on each side of the battery pack
snap into place and battery pack is secured in tool before
beginning operation.
NOTE: Squeeze LED light grip switch to activate stapler.
To remove battery pack:

To remove , locate latches on battery pack and depress
to release battery pack from the tool.
For complete charging instructions, see the operator’s
manuals for your battery pack and charger.
NO-MAR PAD
See Figure 3, page 12.
The no-mar pad attached to the nose of the tool helps pre-
vent marring and denting when working with softer woods.
To remove or replace the pad:
 Remove the battery pack.

Remove the pad by pulling it down and away from the
nose.

To replace the pad, fit it into place over the nose and
push up to reseat.
On-board storage for the pad is located on the magazine of
the tool. An extra no-mar pad is provided in the on-board
storage area.
LOADING THE TOOL WITH STAPLES
See Figures 4 - 5, pages 12 - 13.
WARNING:
Use only the staples recommended for use with this tool.
The use of any other staples can result in tool malfunction,
leading to serious injuries.
WARNING:
Keep the tool pointed away from yourself and others
when loading fasteners. Failure to do so could result in
possible serious personal injury.
 Remove battery pack from the tool, if installed.
 Hold the tool upside down with the nose pointed upward
and tilted away from you.
 Squeeze the magazine release button located at the rear
of the magazine and slide the magazine cover open.

Place staples in the channel with the staple tips point-
ing upward and the crown resting on the bottom of the
channel.