![background image](http://html1.mh-extra.com/html/ryobi/a25rt03/a25rt03_operators-manual_1507407003.webp)
3 - English
GENERAL SAFETY RULES
stripes is the equipment-grounding conductor. If repair
or replacement of the electric cord or plug is necessary,
do not connect the equipment-grounding conductor to a
live terminal. Repair or replace a damaged or worn cord
immediately. Stay constantly aware of cord location and
keep it well away from the rotating blade.
INSPECT EXTENSION CORDS PERIODICALLY
and
replace if damaged.
KEEP TOOL DRY, CLEAN, AND FREE FROM OIL AND
GREASE.
Always use a clean cloth when cleaning. Never
use brake fluids, gasoline, petroleum-based products, or
any solvents to clean tool.
STAY ALERT AND EXERCISE CONTROL.
Watch what
you are doing and use common sense. Do not operate
tool when you are tired. Do not rush.
DO NOT USE TOOL IF SWITCH DOES NOT TURN IT
ON AND OFF.
Have defective switches replaced by an
authorized service center.
DO NOT OPERATE A TOOL WHILE UNDER THE
INFLUENCE OF DRUGS, ALCOHOL, OR ANY
MEDICATION.
WHEN SERVICING
use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
USE ONLY RECOMMENDED ACCESSORIES
listed
in this manual or addendums. Use of accessories that
are not listed may cause the risk of personal injury.
Instructions for safe use of accessories are included
with the accessory.
SPECIFIC SAFETY RULES
FOR YOUR OWN SAFETY
, read this router table
operator’s manual and the router manual before operating
the router or using the router table.
ALWAYS USE THE ARTICULATING ROUTER CUTTER
BIT GUARD.
WHEN USING THE ROUTER ON THE ROUTER TABLE,
the router must be plugged into the router table switch
outlet.
KEEP HANDS AWAY FROM CUTTING AREA.
Do not
reach underneath the table or in the cutting path with your
hands or fingers at any time while the tool is connected
to a power source.
DO NOT USE AWKWARD HAND POSITIONS.
FIRMLY CLAMP OR BOLT THE ROUTER TABLE TO
A WORK SURFACE
so that the router table surface is
approximately hip height.
ALWAYS FEED WORKPIECE AGAINST ROTATION OF
CUTTER.
INSPECT FOR AND REMOVE ALL NAILS FROM
LUMBER BEFORE ROUTING.
Following this rule will
reduce the risk of serious personal injury.
KEEP FINGERS AWAY FROM REVOLVING CUTTER,
USE FIXTURES WHEN NECESSARY.
ALWAYS SUPPORT WORKPIECE FIRMLY AGAINST
TABLE AND FENCE.
IF THE POWER SUPPLY CORD IS DAMAGED,
it must
be replaced only by the manufacturer or by an authorized
service center to avoid risk.
SAVE THESE INSTRUCTIONS.
Refer to them frequently
and use them to instruct others who may use this tool. If
you loan someone this tool, loan them these instructions
also.