
RYCO RYCS10 CUT-OFF SAW
7
13. OPERATING PROCEDURE
1. Position the Hose Support Pins to suit the hose size and type to be cut, as shown in the diagram below. These positions are a guide
only, different Hose Series may require the Hose Support Pins to be moved inwards or outwards to achieve a square cut.
NOTE: the Hose Support Pins on either side of the blade must be an equal distance from the blade.
-06
and
below
-06
and
below
-08
-10
-12
-08
-10
-12
-16
-20
-24
-16
-20
-24
The Hose Support Pins, together with the Support Notch at the bottom of the Operating Lever, remove the need for hand contact on
the hose during cutting.
Figure 4 – RYCS10 Hose Support Pin locations
2. Move the Operating Lever into the back position
3. Mark the hose cut location on the hose, then position the hose to be cut so that:
i)
it is lying flat on the bed of the Saw
ii) it is in contact with both Hose Support Pins; and,
iii) the cut position marked on the hose is aligned with the blade guard slot
NOTE: Do not attempt to cut or trim short pieces from hose. The hose must be in contact with both Hose Support Pins during the entire
cutting cycle.
4. Start the Cut-Off Saw rotation by pressing the Power ON/OFF Switch at the top of the Operating Lever using your thumb.
NOTE: The RYCS10 Cut-Off Saw motor operates only while the Power ON/OFF Switch is depressed.
OPERATING PROCEDURE
RYCO RYCS10 CUT-OFF SAW