6
INSTALLATION
Connecting the Amplifi ed Keypad or
Amplifi er
1. Make sure the keypad or amplifi er is turned off.
2. Strip 1 to 2 inches (2.5 to 5 cm) off the end of each
cable’s jacket. Then strip just enough insulation off
each wire to allow inserting the wires fully into the
keypad’s or amplifi er’s speaker terminals.
3. Twist the wire strands together so there are no
strands separated from the bundle.
4. Connect the wires to the speaker terminals, being
sure to observe proper polarity.
5. Check to make sure there are no stray strands of wire
outside the terminals. If there are, remove the wire,
twist the strands together, and reconnect the wire to
the terminal.
Taking Care of Your Speakers
Your speakers are made of durable materials that need
very little care. All we recommend is an occasional
wiping with a soft, damp cloth. Do not use any harsh
detergents, chemical solvents, or abrasive materials on
your speakers. Also, do not spray water or other liquids
into the grilles.
