Russell Hobbs SMOOTH IQ PLUS RHC700, Инструкции и гарантия

Страница: 7 / 12

7
SWITCHING ON
• Turn the temperature control dial to
'nylon'
and set the steam control to no steam.
• Sit the iron on its heel.
• Plug the power cord into the wall power outlet, and switch it on. A red light will illuminate.
• Turn the temperature control dial to bring the desired setting on the dial next to the
mark on the tank.
• When the iron reaches the set temperature, the light will change to green.
• The temperature ready light will cycle ON and OFF as the thermostat operates to
maintain temperature.
AUTO SHUT-OFF
• If the iron is motionless, the element will switch off after 30 seconds if lying on its soleplate or on
its side and 8 minutes if it is sitting upright.
• The light will blink continuously until you move the iron.
• To switch on again, lift up the iron, tilt it forward and then sit it upright.
• No settings are lost during auto shut-off
REDUCING TEMPERATURE
This can take time, as the iron has to lose the heat it has built up. It is best to organise your
ironing so that you do not need to reduce the temperature.
STEAM IRONING
When steam ironing, you must set the temperature control dial above wool, to ensure the iron
is in the steam temperature range. Make sure the water tank is full.
• Move the steam control to the setting you want.
• Once the light turns off, you can commence ironing.
• The steam control is variable. Choose a position
between the no steam and
high steam that best suits your steam
requirements.
NOTE: When steam ironing at the lower end of the steam
temperature range, it is preferable to set the steam control to
a low steam setting, in order to reduce the incidence of water
droplets.
COOL SPRAY MIST
NOTE: Water spotting affects some fabrics. Test this out on a hidden part of the fabric first. The cool spray
mist works with dry or steam ironing, as long as there is water in the tank.
• Check that there is water in the tank.
• Lift the iron off the fabric.
• Aim the cool spray mist nozzle at the fabric.
• Press the
cool spray mist button – you may have to press it
2 or 3 times to pump water through the system.
cool spray mist button
steam burst
button
cool spray mist button
steam burst
button